***This product is not available for shipping if you do not take the installation.***

 

We offer an optional installation service for the greater Montreal region (North and South shore, Island of Montreal, Laval) . Upon reception of your order, we will contact you between 08:00 and 17:00 pm on the first business day following your order to set-up an appointment for the installation.

 

Here is a practical solution to significantly reduce the accumulation of snow on and in the heat pump. Made from polymers, the Snowguard-S is easily installed on virtually any heat pump models. For the careful and conscientious DIY , install it yourself in less than an hour.

 

The box includes:

 

• Snowguard-L (1)

 

• Ty-rap (8)

 

• Self- tapping screws(12)

 

• Installation instructions

 

The Snowguard-S requires a surface of 29''X29 '' for the 4 brackets to be installed without constraints. The legs are slightly flexible so the Snowguard-S can be install on a 27''X27 '' minimum area.

 

Sit on a bench or at any place where you 'll be able to work safely . Using a drill fitted with a wick of 1/4'',  drill 2 holes distant from each other of an inch on each pallet of each leg . There are 4 legs , so 8 drill holes.

 

Turn off the power of the heat pump . To do this, you can use the service breaker located near the heat pump outside . You can also use the circuit breaker of the heat pump located in the electrical panel of the residence.

 

Place the Snowguard-S on the heat pump. One leg after the other , put a ty- rap in one of the two holes in the pallet of the leg , then pass the ty- rap in the grill above the heat pump fan and  in the second hole of the pallet leg . Then tigh-up the ty- rap and cut off the excess . Make sure not to let the excess ty- rap fall into the heat pump. Repeat for each leg.

 

Put back the power of the heat pump on.

 

The Snowguard-S requires a surface of 29''X29 '' for the 4 brackets to be installed without constraints. The legs are slightly flexible so the Snowguard-S can be install on a 27''X27 '' minimum area.

 

Turn off the power of the heat pump . To do this, you can use the service breaker located near the heat pump outside . You can also use the circuit breaker of the heat pump located in the electrical panel of the residence.

 

WARNING , THE NEXT STEP IS TO BE MADE WITH LOTS OF CAUTION . MAKE SURE YOU DO NOT SCREW SCREWS IN THE HEAT PUMP COIL, THIS COULD RESULT IN A MAJOR FAILURE . IN DOUBT , DO NOT SCREW, STOP AND CALL A PROFESSIONAL . WE RECOMMEND USING OUR INSTALLATION SERVICES.

 

Place the Snowguard-S on the heat pump. Secure each leg of the Snowguard-S by screwing two self- tapping screws in each palette. The screws must pass through the palette and end-up in the heat pump casing.

 

Put back the power of the heat pump on.

MODEL: SNOWGUARD-L

PRICE: 200.00$

** delivery not-included **